rearenginekarts.com

Wanted for a Burris piston with a narrow slot for the 9/16 th wrist pin ... what i need is the rod part number 47832a i believe.

Well fellas i'm after a Mac rod to use in my 101 i have had the block rebored and a Burris .060 piston fitted .... now comes the problem the pin size for this piston is 9/16 and the space for the rod between the pin bosses is narrow so i imagine the rod i'm after would have been used in a Mac 70 / 75 / 100 but i'm not 100% certain can one of the fellas who know's for certain which rod i need as i have a part no 48732a or 48732 as shown in my IPL'S are these part numbers the ones i should be chasing and if possible you have one spare i'd luv to buy it ......

McBob.

McBob.

Bob-

I'll be gone this week for work but I have a whole box of 9/16" rods from various sources. I'll measure some next weekend and see if I have one that works for you. I have some Burris 101 pistons here myself that I can compare rods on.

Thanks ol mate for lookin' hope you find something to get this here old fella outta trouble .......... McBob.