Page 1 of 1
I need a GoPower pyramid reed assembly
Posted: Sun May 08, 2011 8:33 am
by Terry Sullivan
I need a GoPower pyramid reed assembly.
Better yet - a GoPower pyramid reed assembly WITH a manifold for an early McCulloch!
Anybody willing to part with one?
Terry Sullivan
terryas@att.net
678.617.0730
Re: I need a GoPower pyramid reed assembly
Posted: Sun May 08, 2011 12:34 pm
by ted johnson
Terry, I have a NOS Go Power 6 petal reed cage here. I think I have new phenolic reeds. You'd need to edge sand the reeds and find or make the little square washers. You're welcome to it for the postage, if you want it. You've treated me well on the Mac plug covers.
I just dug around in my reed stuff and even found the little washers. The G-10 reeds were cut on a high speed vinyl sign cutting router, and the guy managed to cut them all about 1/32 or 1/16 long, so you'll need to carefully sand the tips shorter. Email me if you want the setup. Ted Johnson
Re: I need a GoPower pyramid reed assembly
Posted: Thu May 12, 2011 2:44 pm
by Tom Smith
Terry, I have 4 manifolds with cages, 1 is for a 9 ported engine, the other 3 still feed the piston port. I think I may have 6 stepper reeds also. =T=