Stroked Mc6 "Clone" SOLD!!!!
Posted: Fri May 31, 2013 2:51 pm
Stroked Mc6 “Clone” for sale.
Features:
Started with a Mac 1-41 saw block, siamese porting on the intake and exhaust, 2 boost ports added with third port wall removed. (see last pic in attached PDF for porting pic)
Fresh bore with 0.020” oversized Mc10 stroker piston (nos), pinned rings.
Mc8 Crankshaft (minor chips on PTO key slot but key fits well and taper has been lapped for a good tight press on the clutch)
NOS Mc8 rod, new bearings, seals and gaskets
Palmini P34 intake manifold with 4 reed pyramid.
Rebuilt Tillotson HL250A gas Carb.
Shaved flywheel
HC Head
Starter cup included
Timed at 26deg BTDC
Pressure checked
Ready to run
$400 Firm plus shipping
Can bring to Avon or TBO
This engine has not been run in it’s current configuration. I have run this engine with the stock Mc6 crank and it ran great so I have no doubt it will be a hot runner for the historic karts.
Features:
Started with a Mac 1-41 saw block, siamese porting on the intake and exhaust, 2 boost ports added with third port wall removed. (see last pic in attached PDF for porting pic)
Fresh bore with 0.020” oversized Mc10 stroker piston (nos), pinned rings.
Mc8 Crankshaft (minor chips on PTO key slot but key fits well and taper has been lapped for a good tight press on the clutch)
NOS Mc8 rod, new bearings, seals and gaskets
Palmini P34 intake manifold with 4 reed pyramid.
Rebuilt Tillotson HL250A gas Carb.
Shaved flywheel
HC Head
Starter cup included
Timed at 26deg BTDC
Pressure checked
Ready to run
$400 Firm plus shipping
Can bring to Avon or TBO
This engine has not been run in it’s current configuration. I have run this engine with the stock Mc6 crank and it ran great so I have no doubt it will be a hot runner for the historic karts.